FS20s
FAQs & Troubleshooting |
How do I thread my machine?
Before threading the needle, be sure to turn off the machine. If you accidentally step on the foot controller and the machine starts to sew, you could be injured.
Raise the presser foot lever to raise the presser foot.
(1) Thread guide | (2) Spring |
* Make sure that the spring in the groove catches the thread.
Feed the upper thread as shown in the following illustration.
(1) Thread take-up lever
* Make sure you guide the thread through the thread take-up lever from right to left as shown in the following illustration.
Slide the thread behind the needle bar thread guide.
(1) Needle bar thread guide
Make sure the main power switch is off when threading the needle.
(1) Turn towards you one full turn until this mark points up to the highest position |
(1) Bobbin thread | (2) Upper thread | (3) Pull out about 10 cm (4 inches) |