CM900
FAQs & Troubleshooting |
What should I do if the results of the region embossing are not clearly defined?
If the embossing is not clearly defined, try the following:
Check that scanning was completed correctly.
If scanning could not be completed correctly, see “What should I do if the pattern does not scan correctly during region embossing?”, and then try scanning again.
Use the φ1.5 mm embossing tool.
Increase the embossing pressure.
When increasing the embossing pressure, change the setting in increments of 1. If the setting is increased drastically, the material may tear.
Adjust the inward offset.
If the embossing edges are too clear, increase the inward offset. If the embossing edges are too faint, decrease the inward offset.
If the inward offset is adjusted too much, embossing cannot be completed correctly.
Adjust the embossing pressure and inward offset in the settings screen for “Premium functions” or embossing screen.
or |
|
When peeling off the scanning support sheet, observe the following.
If the material, template and mat are not correctly aligned, the embossing data will be misaligned, and the embossing cannot be completed correctly.
Use thin paper.