Print  |  Close

HL-3450CN

FAQs & Troubleshooting

FAQs & Troubleshooting

How do I replace the Fuser Cleaner?

Follow the steps below to replace the Fuser Cleaner.

 

 

The Fusing unit and the parts around it are HOT! Be sure to wait until the Fusing Unit has cooled sufficiently before replacing the Fuser Cleaner. If you touch the HOT parts, you might get injured.

 

  1. Press the Power button to turn the printer off and wait until it has cooled down sufficiently.

     

  2. Open the Top Cover.

     

  3. Release the Fuser Cleaner Lock Levers on both sides as shown:

     

  4. Take the Fuser Cleaner out of the Fusing Unit by holding the handle of the Fuser Cleaner as shown below.

     

  5. Install the new Fuser Cleaner into the guide with the roller side facing you.

     

  6. Lock the Fuser Cleaner with the Fuser Cleaner Lock Levers.

     

  7. Close the Top Cover.

     

  8. Press the Power button to turn the printer On.

     

  9. Press any of the Menu buttons (+, -, Set or Back) to take the printer Off Line.

     

  10. Press + or - until "RESET MENU" appears.

     

  11. Press Set to proceed to the next menu level, and then press + or - until "PARTS LIFE" appears.

     

  12. Press Set, and then press +. "FC ROLLER" appears.

     

  13. Press Set, and then press Go. The printer is now in the READY state.
 

Print  |  Close