Innov-is 10/10A
![]() |
Ofte stillede spørgsmål og fejlfinding |
Replacing the needle
Replace the needle as described below.
Use the screwdriver and a needle that has been determined to be straight.
Before using the needle, place the flat side of the needle on a flat surface and check that the distance between the needle and the flat surface is even.
![]() |
(1) Flat side (2) Needle type marking |
Correct needle
![]() |
(1) Flat surface |
Incorrect needle
If the distance between the needle and the flat surface is not even, the needle is bent. Do not use a bent needle.
![]() |
(1) Flat surface |
Do not use a bent needle. Sewing with a bent needle is extremely dangerous since the needle may break while the machine is being operated.
![]() |
(1) Needle position button |
Before replacing the needle, be sure to turn off the sewing machine, otherwise injuries may occur if (start/stop button) is accidentally pressed and the machine starts sewing.
![]() |
(1) Presser foot lever |
Before replacing the needle, place fabric or paper under the presser foot to prevent the needle from falling into the hole in the needle plate.
![]() |
(1) Needle clamp screw (2) Screwdriver |
![]() |
(1) Needle stopper |
Be sure to insert the needle until it touches the needle stopper and securely tighten the needle clamp screw with the screwdriver, otherwise the needle may break or damage may result.