Innov-is A150
![]() |
FAQs & Troubleshooting |
How do I change the needle ?
Before using the needle, place the flat side of the needle on a flat surface and check that the distance between the needle and the flat surface is even.
![]() |
(1) Flat side (2) Needle type marking (3) Flat surface (4) Even (5) Not even |
Replace the needle in cases such as the four described below:
Use the screwdriver and a new needle that has been determined to be straight according to the instructions in "Checking the needle" on the above section.
If is pressed while the presser foot is raised, an error message appears. Lower the presser foot lever and press
again.
When replacing the needle, be sure to press on the operation panel to lock all keys and buttons, otherwise injuries may occur if the “Start/Stop” button or any other button is pressed and the machine starts.
Do not apply a strong force when loosening or tightening the needle clamp screw, otherwise certain parts of the machine may be damaged.
![]() |
(1) Needle stopper |
Be sure to insert the needle until it touches the needle stopper and securely tighten the needle clamp screw with the screwdriver, otherwise the needle may break or damage may result.