SuperGalaxie 3000/3000C/3000D/3100D
FAQs & Troubleshooting |
How do I thread my machine?
Press "BASIC OPERATION" key in that order to display a video example of the operation on the LCD.
Follow the steps explained below to complete the operation.
Be sure to thread the machine properly. Improper threading can cause the thread to tangle and break the needle, leading to injury.
The machine has an upper threading shutter to insure proper threading.
The upper threading shutter opens when the presser foot is raised.
Upper threading can not take place if the presser foot is not raised.
Upper threading shutter |
Spool cap |
When sewing with fine, cross-wound thread, use the small spool cap, and leave a small space between the cap and the thread spool.
Spool cap (small) Thread spool (cross-wound thread) Space |
Corner of the thread guide |
Be sure to lower the presser foot lever.
Continuing without lowering the lever may cause damage to the machine.
Hook |
Do not pull the thread too strongly, as you may bend the needle.
The needle threader lever can only be used with home sewing machine needles size 75/11-100/16.
Check the table on page 1-45 for appropriate needle and thread combinations.
Note that, if you are using transparent nylon mono-filament thread, only needles in the range of 90/14-100/16 can be used.
100mm (3inch - 4inch) |