SDX125e
FAQs & Troubleshooting |
Using the trimmer blade to trim the end of the material
If the left and right edges of the material to be cut with the roll feeder are not parallel or both corners are not at right angles, the end of the material can be trimmed with the trimmer blade.
(1) Guide channel |
(1) Trimmer |
(1) Hole in trimmer (2) Pin on base attachment |
(1) Rolled material guide |
(1) Trimmer blade (2) Trimmer |
The trimmer blade can cut material only when it is slid from the right end of the trimmer. It cannot cut if it is slid from any location other than the right end. The trimmer blade slides only one direction as indicated. Forcing the trimmer blade in another manner may damage the attachment.
(1) Rolled material guide (2) Trimmer (3) Trimmer blade |
If the material does not cut easily
If cutting does not start smoothly, for example, if the material catches on the blade, instead of sliding the blade with excessive force, refer to the following and try again. Sliding the trimmer blade with excessive force may cause damage.
(1) Trimmer |
Remove the trimmer and store at the front of the roll holder.