DC200
![]() |
FAQs & Troubleshooting |
How to set up the wireless connection using router’s WPS button. (Computer Instructions)
Follow the instructions below to connect the machine and computer using wireless LAN.
Installing DesignNCut Manager on your computer
Setting the wireless connection using WPS button
If your wireless LAN access point/router is equipped with a WPS (Wi-Fi Protected Setup™) button, locate it and proceed with the following steps:
To use WPS, your wireless access point/router must support WPS. Confirm your wireless access point/router has the WPS symbol as shown below. For more details, refer to the instructions provided with your access point/router.
When the Welcome To DesignNCut Manager appears on your screen follow the on-screen instructions.
Click Connection Guide to access the step by step instructions.
Turn off the machine by pressing .
Press and the
on the operation panel at the same time, once the power comes on release
while still pressing down
.
When the message Machine mode? appears on the machine’s LCD, press to select WLAN.
When the message Turn the machine off, then on again. appears, turn the machine off, then on again.
When the setting is changed, the message Standby (WLAN) appears.
Press your router's WPS button.
The location of the WPS button differs depending on your device.
When the message Enable WLAN? appears on the machine’s LCD, press to select Yes.
Give your machine time to connect to your wireless network.
When the message Connected to WLAN. Press [OK] button. appears on the machine’s LCD, presson your machine.
The Wireless LAN Connect light will turn on.
![]() |
(1) Wireless LAN Connect light |
Go back to DesignNCut Manager and click [Connect] .
Select the machine number and then click [OK] .
Depending on the settings of the wireless LAN access point/router, the machine name may not be displayed correctly. In that case, select the number or letter that is listed in the screen, and click [OK] .
To check your machine's number, press to display the 2. Machine Info on the machine’s LCD, and then press
. When 1. No. appears on the LCD, press
.
Your machine’s number will be displayed on the machine’s LCD.
When DesignNCut Connection is successful. appears in the dialog box, click [OK] .
Create a CanvasWorkspace (Web) account.
- If you created an account, click [Next] and continue to step 18.
- If no, click CanvasWorkspace (Web) on the following screen to access to <https://canvasworkspace.brother.com> to register a new account.
After registering, click [Next] and go to step 18.
Click [Connect] .
Register dialog box will appear.
Type in the login ID and password registered with CanvasWorkspace (Web), and then click [Register] .
When the ScanNCut Online Settings has been completed dialog box appears, click [OK] .
Click [Next].
Once you completed the connection and CanvasWorkspace (Web) registration you can create a pattern on CanvasWorkspace (Web) <https://canvasworkspace.brother.com> and cut the data with DesignNCut by operating DesignNCut Manager.
Refer to How do I transfer the pattern (to cut, draw, line emboss, etc.) using a Wireless LAN connection?
Click [How to Use] on the DesignNCut Manager to see tutorial for the basic usage.
After the settings have been completed, your machine number and your CanvasWorkspace (Web) login ID will be shown in the DesignNCut Manager’s main window.