PRS100
FAQs & Troubleshooting |
How do I attach or remove the embroidery frame ?
After hooping the fabric in the embroidery frame, attach the frame to the embroidery machine.
Before attaching the embroidery frame, check that there is enough thread in the bobbin.
Adjust the width of the embroidery frame holder to the size of the embroidery frame, and then attach the embroidery frame to the machine. As an example, the procedure for attaching the medium embroidery frame is described below.
|
(1) Left arm of embroidery frame holder Move the arm of the embroidery frame holder to the left or right to adjust it to the size of the embroidery frame. (2) Clip on embroidery frame holder. Insert the embroidery frame into the clips on the embroidery frame holder. (3) Positioning pin (4) Holes (5) Positioning slots |
(1) Left arm
(2) Thumb screws → The left arm of the embroidery frame holder can be moved. |
Only loosen the thumb screws a maximum of 2 turns counterclockwise. Do not remove the screw.
For this example, align with mark (3).
(1) Mark for extra-large embroidery frame
(2) Mark for large embroidery frame (3) Mark for medium embroidery frame (4) Mark for small embroidery frame (5) Align the screw with the mark. |
Please firmly tighten the two thumb screws with included disc-shaped screwdriver. The machine will recognize the wrong frame size, if the two screws are not tightened.
→ The embroidery frame holder is ready for the embroidery frame to be attached.
Hold the embroidery frame level, and then simultaneously align both the left and right mounts with the embroidery frame holder clips. The inner frame should be on top.
If the outer frame is on top, as shown below, the embroidery frame is incorrectly attached.
Insert the embroidery frame until it snaps into place.
(1) Make sure that the pins on the left and right arms of the embroidery frame holder fit into the positioning slot and hole on the embroidery frame. |
After embroidering is finished, remove the embroidery frame, and then remove the fabric from the frame.