CE6070T
![]() |
FAQs & Troubleshooting |
How do I wind the bobbin?
![]() |
(1) Bobbin-winding thread guide (2) Bobbin winder shaft (3) Bobbin |
![]() |
(1) This model (2) Other models |
Do not grab the bar to raise the spool pin, otherwise, the spool pin may bend or break.
![]() |
(1) Spool pin (2) Spool cap |
Be sure to raise the spool pin when winding the bobbin.
The thread may become tangled if the bobbin winder is used without raising the spool pin.
When sewing with fine, cross-wound thread, use the small spool cap, and leave a small space between the cap and the spool.
![]() |
(1) Spool cap (small) (2) Spool (cross-wound thread) (3) Space |
![]() |
(1) Thread guide |
![]() |
(1) Thread guide cover |
![]() |
(1) Bobbin-winding thread guide |
Make sure that the thread passes under the pretension disk.
![]() |
(2) Hook (3) Pretension disk (4) Pull it in as far as possible. |
![]() |
(1) Spring on the shaft (2) Notch (3) 7-10 cm (2-3/4 – 3-15/16 inches) |
Pull the thread taut and hold the end of the thread straight up. If the thread is too short, not pulled taut or held at an angle, injuries may occur when the thread is wound around the bobbin.
When the bobbin seems full and begins spinning slowly, take your foot off the foot controller.
Not winding the bobbin properly may cause the thread tension to loosen, and may break the needle.