PR1050X
FAQs & Troubleshooting |
Specifying jumpstitch trimming or DST jump codes for trimming
You can specify whether or not jumpstitches are cut.
In addition, when using Tajima embroidery data (.dst), you can specify whether or not the thread is cut according to the specified number of jump codes.
ON : The machine cuts the upper and bobbin thread before the jumpstitch. When Tajima embroidery data (.dst) is used, the machine converts the "jump" code to a trim code, based on the number specified on the next line.
OFF : The machine does not cut either a jumpstitch or the "jump" code in Tajima embroidery data (.dst).
When the machine is purchased, "ON" is selected.
A value between 1 and 8 can be specified.
For example, if 3 is specified, sequential 3 jump codes will be converted to the trim code. But sequential 2 jump codes will not be converted to the trim code, it will be sewed as the feed (jump) stitch.
When the machine is purchased, the number of jumps is set to "3".