SDX1200
FAQs & Troubleshooting |
The rolled material did not feed correctly.
If rolled material is not fed correctly, check the following.
Non-Compatible Material :
Others :
Non-Compatible Material :
【The left and right edges of the material are parallel, and both corners are at right angles】 | |||
|
|||
|
|||
As shown below, if the left and right edges of the material are not parallel or both corners are not at right angles when the material feeds, it loses contact with the feed roller, causing the material to become skewed and feed incorrectly. | |||
【The left and right edges of the material are not parallel】 | |||
|
|||
【The left and right edges of the material are parallel, and both corners are not at right angles】 | |||
|
|||
|
The trimmer blade can be used to trim the end of the material.
For details on trimming the end of the material, refer to Using the roll feeder to trim the end of material.
【Rolled with the backing paper (backing film) on the inside (bottom, facing down)】
When the end of the material is flat, it will feed correctly. |
|||
|
|||
【Rolled with the backing paper (backing film) on the outside (top side/facing up)】
When the end of the material curls upward, it will not feed correctly. |
|||
|
Others :
(1) Pin on guide plate (2) Support rollers |
(1) Adjustment lever |
The material is correctly loaded when there is a gap of about 2 to 3 mm between the guide plate and the right side of the roll. After aligning the left edge of the material, adjust the guide plate.
(1) Gap of about 2 to 3 mm |