Innov-is XV8500D
![]() |
FAQs & Troubleshooting |
When the thread became tangled under the bobbin winder seat
If the bobbin winding starts when the thread is not passed through the pre-tension disk correctly, the thread may become tangled beneath the bobbin winder seat.
Wind off the thread according to the following procedure.
![]() |
(1) Thread (2) Bobbin winder seat |
(The screen may differ depending on the model.)
![]() |
(1) Pre-tension disk |
Cut the thread near the bobbin to completely remove the bobbin from the shaft.
Hold the thread end with your left hand, and wind off the thread clockwise from under the bobbin winder seat with your right hand as shown below.
Make sure that the thread passes through the pre-tension disk correctly.