XT37
FAQs & Troubleshooting |
(1) Spool pin
(2) Thread guide
(3) Thread take-up lever
(4) Mark on the handwheel
(1) Presser foot lever
(1) Mark on the wheel
If the needle is not correctly raised, the sewing machine can not be threaded.
(1) Spool pin
(2) Spool cap
Slide the spool onto the pin so that the spool is horizontal and the thread unwinds to the front at the bottom.
When sewing with fine, cross-wound thread, use the small spool cap, and leave a small space between the cap and the spool.
(1) Spool cap (small) (2) Spool (cross-wound thread) (3) Space |
(1)Thread guide "A"
(1) Thread guide "B"
Hold the thread with your right hand so that there is no slack in the thread that is pulled out, and then pass the thread under the thread guide B with your left hand.
(1) Thread take-up lever
If the thread take-up lever is lowered, the upper thread can not be wrapped around the thread take-up lever. Make sure you raise the needle by turning the handwheel toward you (counterclockwise) so that the mark on the wheel points up.
(1) Needle bar thread guide
(1) Presser foot lever
(1) Mark on the wheel
(1) Needle holder
(2) Needle threader lever
(3) Guide
(1) Hook
(2) Thread
Hold the thread in front of the needle to make sure that the hook grabs it.
(1) Loop of thread
Be careful not to pull on the thread with force or it may bend the needle.
(1) Presser foot lever
(1) 5 cm (2 inches)
If you incorrectly feed the thread you may cause sewing problems.