There may be some sewing applications where you want to pull up the bobbin thread; for example, when making gathers, darts, or doing free motion quilting or embroidery.
You can pull up the bobbin thread after threading the upper thread. Refer to “How do I thread my machine ?” to thread the machine with the upper thread and thread the needle.
Touch to lock all keys and buttons and raise the presser foot.
If the message " OK to automatically lower the presser foot? " appears on the LCD screen, touch [OK] to continue.
Slide the bobbin cover latch to the right and remove the bobbin cover.
Hold the bobbin with your right hand and hold the end of the thread with your left hand. Set the bobbin in the bobbin case so that the thread unwinds to the left.
Guide the bobbin thread through the groove, following the arrow in the illustration.
Do not cut the thread with the cutter.
Do not replace the bobbin cover.
Touch [key] to unlock all keys and buttons.
While holding the upper thread, press (Needle position button) to lower the needle.
Press (Needle position button) to raise the needle.
Gently pull the upper thread. A loop of the bobbin thread will come out of the hole in the needle plate.
Pull up the bobbin thread, pass it under the presser foot and pull it about 10 cm (approx. 4 inches) toward the back of the machine, making it even with the upper thread.
Reattach the bobbin cover.
* Insert the tab in the lower-left corner of the bobbin cover (A), and then lightly press down on the right side to close the cover (B).
to lock all keys and buttons and raise the presser foot.
[key] to unlock all keys and buttons.
(Needle position button) to lower the needle.
(Needle position button) to raise the needle.
