PR-650/650C

FAQs & Troubleshooting

FAQs & Troubleshooting

Embroidery

  • One problem that may occur during embroidery is misalignment of the pattern.  Misaligned patterns may result when the fabric is loosely set in an embroidery frame.  Make sure fabric is set tightly in the embroidery frame so that it sounds like a drum if you were to tap lightly on the fabric.

     

    One Point Advice : Hooping the fabric

 

 

  • Use an iron-on stabilizer when sewing thin fabrics, stretch fabrics or fabrics which easily pucker. Prepare a stabilizer material that is larger than the embroidery frame to be used. Make sure to attach the correct surface of the iron-on stabilizer to the fabric securely with an iron.
     

    image
          (1) Adhesive side of iron-on stabilizer (backing)
          (2) Fabric (wrong side)

     

    One Point Advice : Stabilizers (Backing)

    One Point Advice : Fabric/stabilizer compatibility chart

    When embroidering fabric that should not be ironed or when embroidering an area that is difficult to iron, hoop a layer of the iron-on stabilizer under the fabric in the embroidery frame without ironing.

 

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

PR-1000, PR1000e, PR-600/600C, PR-620/620C/600II/600IIC, PR-650/650C, PR650e/PR650eC, PR655/PR655C

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.