I installed the RD roll, but the message "No paper" appears.

Please check that the end of the RD roll feeds under the gap (media) sensor and it can be seen from the other side.

 

If the end of the RD roll has not been fed under the gap (media) sensor, the TD-4000/4100N may not be able to detect the media properly.

setting the roll

 

 

If not, turn the machine off and reinstall the RD roll as the illustration below.

 

Insert a RD roll into the roll compartment upside down with the labels feeding from the bottom as shown. Check the position of the roll guide and adjust it to prevent the RD roll from moving sideways.

setting the roll

 

Position the end of the RD roll to touch the black plastic cutter guard.

setting the roll

 

 

Turn the machine back on and then press the Feed button to set the roll.

If your question was not answered, have you checked other FAQs?

Have you checked manuals?

If you need further assistance, please contact Brother customer service:

Related Models

TD-4000, TD-4100N

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.