TD-4520TN

FAQs & Troubleshooting

FAQs & Troubleshooting
  • Date: 13/03/2019
  • ID: faqp00100465_000

Printing the printer configuration (Self-test)

The printer will print the printer configuration after the Gap/Black Mark Sensor calibration. (To print the Self-test printouts, see the FAQ: "How to execute the printer configuration (Self-test) to debug".)

Self-test printouts list the printer's configuration and available memory space, and can indicate whether there is any dot damage on the heater component.

 

Self-test printout

System Information

1. Model name
2. F/W version
3. Firmware checksum
4. Printer S/N
5. Configuration file
6. System date
7. System time
8. Printed mileage (meter)
9. Cutting counter
10. Number of bad dot in the print head
Printing Setting 1. Print speed (inch/sec)
2. Print darkness
3. Label size (inch)
4. Gap distance (inch)
5. Gap/Black Mark Sensor sensitivity
6. Code page
7. Country code
Z Setting ZPL setting information
1. Print darkness
2. Print speed (inch/sec)
3. Label size
4. Control prefix
5. Format prefix
6. Delimiter prefix
7. Printer power up motion
8. Printer head close motion

ZPL is emulating for Zebra® language.
RS232 SETTING RS232 serial port configuration
Ethernet Setting 1．Printer name
2．Mac Address
3．DHCP
4．IP Address
5．Subnet Mask
6．Gateway
7．RAW Port
Number of Files 1. Numbers of download files
   Total & available memory space
2. Print head check pattern

If your question was not answered, have you checked other FAQs?

Have you checked manuals?

If you need further assistance, please contact Brother customer service:

Related Models

TD-4420TN, TD-4520TN

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.

Submit