TD-4520TN

FAQs & Troubleshooting

FAQs & Troubleshooting

How to attach the External Roll Mount (Optional)

Movie: How to attach the External Roll Mount (Optional)

*The video clip is being streamed from YouTube.

 

 

  1. Tighten the screws of the metal fittings of the extended plate.
    Extended plate

  2. Attach the extended plate to the bottom of the printer.

  3. Insert a 76.2 mm (3") Label Spindle into the paper roll. Then, install it on the External Roll Mount.

    1. 76.2 mm (3") Label Spindle

  4. Feed the media through the Rear Label Feed Slot.

  5. Open the Roll Compartment Cover. Slide the Roll Guides outwards, and then align the paper width with the Roll Guides. Push down the LOCK switch to lock the Roll Guides.

  6. Install the label. Turn the Media Guide Hub, and match the media guide width to the paper width.

  7. Use the BPM (Brother Printer Management Tool) to set the paper size and the media sensor type, and calibrate the selected sensor.
     
    1. Start the BPM. > Click the Printer Configuration button. > Set the Paper Width, Paper Height, Media Sensor and Gap in the FBPL tab, and click the Set button. > Make sure that the settings is activated by clicking the Get button.
      Printer Configuration

    2. Click the Printer Function button. > Set the media sensor type, and click the Calibrate button.
      Calibrate

    Calibrate the Gap/Black Mark Sensor when changing media.

If your question was not answered, have you checked other FAQs?

Have you checked manuals?

If you need further assistance, please contact Brother customer service:

Related Models

TD-4420TN, TD-4520TN

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.