Innov-is 30

FAQs & Troubleshooting

FAQs & Troubleshooting

How do I sew hook-and-loop fasteners(hook-and-loop tapes)?

 

 

  • Use only the ungummed hook-and-loop fastener which is for sewing. If the glue is attached to the needle or the bobbin hook race, it may cause malfunction.
  • If the hook-and-loop is sewn with the thin needle (65/9-75/11), the needle may bend or break.
  • Before start sewing, baste together the fabric and the hook-and-loop fastener.

 

 

 

Make sure that the needle passes through the hookand-loop fastener by turning the handwheel and lower the needle into the hook-and-loop fastener before sewing. And then, sew the edge of the hookand-loop fastener at a slow speed.
If the needle does not pass through the hook-andloop fastener, replace the needle with the needle for thick fabrics.

hook-and-loop fastener 1 Edge of the hook-and-loop fastener
 

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

AS1430S, AS2730S, BM-3500/2600, DS-140, FS101, FS50, GS2500, GS2700, Innov-is 30, Innov-is 35P, Innov-is 50, Innov-is 55P, Innov-is 900, Innov-is 950, Innov-is 955, JA1400, JA1450NT, JK17B, JS1410, LS-2125/2160

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.