HL-B2000D
FAQs & Troubleshooting |
Replace Drum
The Brother machine has separate consumables the toner cartridge and the drum unit. Verify you replace only the drum unit and not the toner cartridge.
> Click here to see information for the difference between the toner cartridge and the drum unit.
Replace the drum following the steps below:
Replacing the drum unit
NOTE: Illustrations shown below are from a representative product and may differ from your Brother machine.
- Make sure the machine is turned on.
-
Open the front cover.
-
Remove the toner cartridge and drum unit assembly from the machine.
-
Push down the green lock lever, and then take the toner cartridge out of the drum unit as shown in the illustration.
To avoid staining toner on your hands or clothes, DO NOT touch the shaded parts shown in the illustrations.
- Unpack the new drum unit.
-
Push the toner cartridge firmly into the new drum unit until you hear it lock into place.
Make sure you put the toner cartridge in correctly or it may separate from the drum unit.
-
Install the toner cartridge and drum unit assembly back into the machine.
- Close the front cover of the machine.
Reset the drum counter
When you replace the drum unit with a new one, you must reset the drum counter by completing the following steps:
- Make sure the machine is turned on.
- Make sure that the front cover is open.
- Press and hold Go for about four seconds until all of the LEDs light up. When all four LEDs are lit, release Go.
- Close the front cover.
- Make sure the Drum LED is now off