Model discontinued. This page is no longer updated.

HL-2600CN

FAQs & Troubleshooting

FAQs & Troubleshooting

What kind of memory can I use?


This printer has 64 Mbytes of standard memory and 3 slots for optional expansion memory. The memory can be expanded by 384 Mbytes by installing commercially available dual in-line memory modules (DIMMs). (The standard memory fitted can vary depending on the printer model and the country.).

 

The installation of additional memory can help the printer process the print job faster and reduce the chance of the printer running out of memory if you are printing complex graphical print jobs.

 

This printer uses memory modules that are:

100 pins, no-parity, SDRAM with 64Mbit or more.

This printer is not compatible with Extended Data Output (EDO) DIMM, or DIMM that uses 16Mbit SDRAM.

The following capacity of DIMMs can be installed:

<Europe>

Size
Manufacture
No.
 16  MB BUFFALO TECHNOLOGY 12323-0001
 32  MB BUFFALO TECHNOLOGY 12324-0001
 64  MB BUFFALO TECHNOLOGY 12325-0001
128 MB BUFFALO TECHNOLOGY 12326-0001

 

<USA>

Size
Manufacture
No.
 16  MB TECHWORKS 12456-0001
 32  MB TECHWORKS 12457-0001
 64  MB TECHWORKS 12458-0001
128 MB TECHWORKS 12459-0001

 

For more information, visit Techworks/Buffalo web site at http://www.techworks.com/

 

In general, the DIMM must have the following specifications:

 Type:  100 pin and 32 bit output
 CAS Latency:  2
 Clock frequency:  66 MHz or more
 Capacity:  16, 32, 64 MB or 128 MB
 Height:  46 mm (1.8 inches) or less
 Parity:  None
 DRAM Type:

 64M bit SDRAM 4 Bank
* SDRAM can be used.

For more information, consult with the dealer where you purchased the printer.

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

HL-2600CN

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: €Are there any comments you would like to add?

Please note this form is used for feedback only.