TJ-4010TN

FAQs & Troubleshooting

FAQs & Troubleshooting

How to reset the printer settings by directly operating the printer

Printer initialization clears the printer's DRAM and restores its factory settings.

 

  1. Turn off the printer.

  2. Press and hold the Pause and Feed button, and then turn on the printer.

  3. Release the button when the Power LED is blinking in green (5 times).

    The LED color will change as follows:

    Amber > red (5 times) > amber (5 times) > green (5 times) > green/amber (5 times) > red/amber (5 times) > green (lit)

After the initialization, the following factory settings will be restored:

Parameter Default setting
Speed 127 mm/sec (5 ips) (203 DPI)
76 mm/sec (3 ips) (300 DPI)
Density 8
Label Width 101.5 mm (4")
Label Height 101.5 mm (4")
Sensor Type Gap sensor: TJ-4020TN, TJ-4021TN, TJ-4120TN, TJ-4121TN
Black sensor: TJ-4021TNR, TJ-4121TNR
Gap Setting 3 mm (0.12")
Print Direction 0
Reference Point 0,0 (upper left corner)
Offset 0
Tear Mode On
Peeler Mode Off
Cutter Mode Off
Rewinder Mode Off
Code Page 850
Country Code 001
Clear Flash Memory No

If your question was not answered, have you checked other FAQs?

Have you checked manuals?

If you need further assistance, please contact Brother customer service:

Related Models

TJ-4010TN, TJ-4020TN, TJ-4120TN

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.