Innov-is XP3

FAQs & Troubleshooting

FAQs & Troubleshooting

Machine does not start to sew.

 

If the machine does not start when you press the Start/Stop button or press the Foot controller, check the following possible causes and solutions.

 

 

  • There is no stitch selected.

    Select a stitch pattern.
    For details on selecting a stitch pattern, refer to "Basic procedure to sew stitches".


     
  • Presser foot is not lowered.

    Lower the presser foot.

    Refer to "Basic procedure to sew stitches".


     
  • Start/Stop button was pressed with the foot controller attached.

    When the foot controller is connected, you cannot use the Start/Stop button.
    Remove the foot controller to use the Start/Stop button, or use the foot controller to operate the machine.


     
  • The Start/Stop button was pressed while the machine is set to the mode to adjust the zigzag stitch width with the speed control slide. ([Width Control] is set to [ON] in the machine's setting screen).

    When [Width Control] is set to [ON] in the setting screen, you cannot use the Start/Stop button.
    Set the [Width Control] to OFF in the settings screen to use the Start/Stop button, or use the foot controller to operate the machine.

    img01

    Refer to "When the speed controller is set to control the zigzag stitch width, the "Start/Stop" button does not operate." appears on the LCD".


     
  • The operation buttons and keys are locked by being set to the presser foot/needle exchange mode.

    Touch the Presser foot/Needle exchange key img02 to unlock the keys and buttons.

    img03

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

Innov-is XP1, Innov-is XP2, Innov-is XP3

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.