Introduction

This machine supports a wireless network connection. Using this function, an embroidery pattern or decorative stitch pattern edited in embroidery editing software (PE-DESIGN 11) with wireless transfer functions can be transferred to the machine from a computer. In addition, embroidery patterns can be transferred from the machine to the embroidery editing software (PE-DESIGN 11). The machine and computer must be connected to the same network. For detailed procedures, refer to the manual for the application.

(1) Wireless network access point/router
(2) Computer connected to wireless network access point/router and the embroidery editing software (PE-DESIGN 11)
(3) Your machine (Innov-Ís XP1)

Requirements for a Wireless Network Connection

The wireless network connection complies with IEEE 802.11 n/g/b standards and uses the 2.4 GHz frequency.

Setting up the wireless network connection

In order to to set up the wireless network connection, we recommend the method that uses the wizard on this machine.

1. Before setting up

In order to connect your machine to a wireless network, the security information (SSID and network key) for your home network will be required. The network key may also be called a password, security key or encryption key. First, find your security information and note it.

2. Specifying wireless network connection settings

1. Press to display the settings screen.
   
   
    
2. Press to go to Wireless LAN settings screen.
   
   
    
3. Set "Wireless LAN Enable" to "ON".
   
   
   ⇒ The machine will begin to emit the wireless network signal.

3. Using the wizard to set up the wireless network connection

There are multiple ways to set up the wireless network connection. We recommend the method that uses the wizard on this machine.
 

1. Press Wireless LAN Setup Wizard.
   
   
   ⇒ A list of available SSIDs appears.
    
2. Select your Network Name (SSID) in the list of SSIDs.
   

   (1)	Network SSID	The network SSIDs are appeared in the list.
   (2)	Refresh	If the desired network SSID does not appear in the list, press Refresh key.
   (3)	Saved SSID	If the machine had already been connected to the home network, press "Saved SSID" key , and then select the saved SSID.
   (4)	New SSID	If the desired network SSID is not displayed, specify it as described below. Press "New SSID" key. Enter the desired network SSID, and then press OK key. Select the authentication method and encryption mode. Follow steps indicated on the screen.

   
   ⇒ The screen for entering the network key (password) appears.
   
    
3. Enter the network key (password) that was noted, and then press OK key.
   
    

   (1)	Text input area
   (2)	Character keys
   (3)	Caps key
   (4)	Letters key
   (5)	Numbers key
   (6)	Symbols key
   (7)	Cursor keys (Move the cursor to the right)
   (8)	Cursor keys (Move the cursor to the left)
   (9)	Backspace key (Deletes the character at the cursor's position.)

   
    
4. When the message "Apply Settings?" appears, press OK key.
   
   
   ⇒ When a connection is established, the message "Connected to wireless LAN" appears. To close the message screen, press OK key.
   
   
    
5. Press OK key to exit the setup.