SDX125e Titanium

FAQs & Troubleshooting

FAQs & Troubleshooting

What should I do if the scanned and cut positions are misaligned?

If the scanned and cut positions are misaligned, they can be manually adjusted.

 

Prepare the following.

Paper :

White thick paper

Size: A4 (210 mm (8.3") × 297 mm (11.7")) or Letter (216 mm (8.5") × 279 mm (11.0"))
Thickness: 0.2 mm (0.008") to 0.3 mm (0.012 in)  (recommended)

Mat : Mat appropriate for the material
For details, see Mat, Cutting Blade and Material Combinations
Cutting blade : Auto Blade Holder (black)

 

Be sure to first test attach it to a mat suitable for the paper.


 

 

 

  1. Insert the holder into the carriage.



     

  2. Attach the paper to the mat.

    image (1) Long side
    (2) Short side

    Align the upper-left corner of the paper with the upper-left corner of the mat.

     
     

  3. Touch the Scanning/Cutting Position Adjustment in the settings screen.

    image



    The following message appears.

    image


    Touch the OK key.



     

  4. Insert the end of the mat marked with an arrow into the machine.

    image

    (1) Guides

    (2) Feed rollers


     

  5. While holding the mat level and lightly inserting it into the feed slot, press  in the operation panel.


     

     

  6. Make sure that the scanner lever (on the left side of the machine) is lowered to “1”.
    image


     

  7. Touch the Start key to start cutting.

    image




    Using the intersecting cuts on the left and right sides, the scanning position is automatically adjusted.

    image



     

  8. The adjustment results screen appears.

    image 


    If the center of the cut aligns with the center of the red circle, the position is properly adjusted.
    Touch the Yes key, and then continue with step 8.


    If the center of the cut does not align with the center of the red circle, the position is improperly adjusted.
    Touch the No key, replace the paper attached to the mat, and then repeat steps 4 through 7 to readjust the position.
     


     

  9. When the following message appears, touch the OK key.

    image

    The adjustment is finished.
     

    To return the settings to their defaults, touch the Reset key in the screen shown below.
    image



     

  10. Use Direct Cut mode to check the adjustment results.

     

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

SDX125, SDX125e, SDX125e Titanium, SDX125i, SDX125TS, SDX135PRO, SDX225, SDX225F, SDX230D, SDX230Di, SDX230DX, SDX325, SDX330D, SDX85, SDX85C, SDX85M, SDX85S

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.