SDX125e
 |
FAQs & Troubleshooting |
The mat is fed in at an angle.
Possible Causes (or Results)
| Case1 : |
The mat was inserted into the feed slot at an angle. |
| Case2 : |
The corners of the mat are deformed (bent). |
| Case3 : |
The rear tray is not pulled out. |
| Case4 : |
The feed roller is not positioned correctly. |
| Case5 : |
The shaft is released. |
Solutions
----- Case1 -----
Press the 
(Feed) button to feed out the mat.
Re-insert the mat straight in.
----- Case2 -----
Replace the mat with a new one.
----- Case3 -----
Pull out the rear tray.
----- Case4 -----
Adjust the position of the feed roller.
For details, refer to Adjusting the Position of the Feed Roller
----- Case5 -----
Lock the shaft.
If your question was not answered, have you checked other FAQs?
Have you checked the manuals?
If you need further assistance, please contact Brother customer service:
Related Models
SDX125, SDX125e, SDX125e Titanium, SDX125i, SDX125TS, SDX135PRO, SDX225, SDX225F, SDX230D, SDX230Di, SDX230DX, SDX325, SDX330D, SDX85, SDX85C, SDX85M, SDX85S
Content Feedback
To help us improve our support, please provide your feedback below.
