LB6810

FAQs & Troubleshooting

FAQs & Troubleshooting

How do I raise or lower the feed dogs?

Use the feed dog position switch to raise or lower the feed dogs.

 

The position of the feed dog position switch depending on your machine

Feed dog position switch

1 Feed dog position switch (as seen from the rear of the machine)

Feed dog position switch

1 Feed dog position switch (as seen from the front of the machine)

Feed dog position switch

1 Feed dog position switch (as seen from the rear of the machine)

The feed dogs are up The feed dogs are up and will help guide the fabric.
The feed dogs are down

The feed dogs are down and will not help guide the fabric.

(Use this position when sewing, such as free-motion quilting or button sewing.)

  • Raise the presser foot lever, and then slide the lever of the feed dog position switch.
  • Set the lever in the The feed dogs are up position for normal sewing.
  • The feed dogs can not be raised only by sliding the drop feed lever to The feed dogs are up.
    Raise the feed dogs as described below.
    1. Slide the drop feed lever to The feed dogs are up.
    2. Turn the handwheel toward you (counterclockwise), or press the "Needle Position" button once or twice.

 

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

HE-240, HE300, Innov-is 1000, Innov-is 1200, Innov-is 1250D, Innov-is 1500D/1500, Innov-is 4000D/4000, Innov-is 4500D, Innov-is 4750D, Innov-is 900D, Innov-is 950D, Innov-is 990D, LB6770/6770PRW, LB-6800, LB6810, NX-200, NX-250, NX-400Q/400, NX-450/450Q, NX570Q, NX-600, NX-650Q, PC-210/210PRW, PC-420/420PRW, SB3129, SB4138, SB7500, SB8000, SE1800, SE-350, SE-400, SE425, ULT2001/2001N/2001C/2002D/2003D

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.