Model discontinued. This page is no longer updated.

HL-5070N

FAQs & Troubleshooting

FAQs & Troubleshooting

Printouts (envelopes) have creases.

Please do the following:


If envelops were creased after they have been printed, please take the following countermeasures:
  1. Firstly, please change a paper size setting to "DL Long Edge" at printer driver properties.
    And then put in envelopes sideways, and print again.

 

  1. At the back of the printer, open the back output tray and push down the blue tabs at the left and right hand sides (as shown in the figure below). When you have finished printing your envelopes, close the back output tray to reset the two blue tabs back to their original position.

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

HL-5030, HL-5040, HL-5050, HL-5070N

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.