How to install the rechargeable Li-ion battery (optional)

Installing the rechargeable Li-ion battery

 

  1. Move the Battery Latch 1 to the unlock position.

  2. While holding the Battery Latch 2 in the unlock position, remove the Battery Cavity Mounting Block.
    Removing charging terminal protection case 1. Battery Latch 1
    2. Battery Latch 2
    3. Battery Cavity Mounting Block

  3. Release the Battery Latch 2.
    The Battery latch 2 moves back to the lock position.

  4. Insert the battery into the battery cavity until it locks into place.
    Inserting rechargeable Li-ion battery 4. Battery cavity
    5. Rechargeable Li-ion battery

  5. Move the Battery Latch 1 to the lock position.
    Moving battery latch 1
    • The voltage supplied by the rechargeable Li-ion battery may vary.  The printing speed may also vary depending on the voltage.
    • When the battery is being used, the battery cavity mounting block is not needed.  Keep it in a safe place to avoid losing it.

Removing the rechargeable Li-ion battery

 

  1. Move the Battery Latches to the unlock position, and then remove the battery.
    Removing rechargeable Li-ion battery 1. Battery latches

  2. Insert the Battery Cavity Mounting Block into the battery cavity until it locks into place.

  3. Move the Battery Latch 1 to the lock position.

If your question was not answered, have you checked other FAQs?

Have you checked manuals?

If you need further assistance, please contact Brother customer service:

Related Models

PJ-722, PJ-723, PJ-762, PJ-763, PJ-763MFi, PJ-773

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.