NC-2200w
FAQs & Troubleshooting |
I cannot configure the NC-2200w. What can I do?
If the NC-2200w cannot be found using the 'Wireless Setup Wizard' or the 'BRAdmin Professional' software, check the following:
Check the connection between the NC-2200w and the Printer/MFC/DCP:
Press the 'Test' button of the NC-2200w for 1-2 seconds to print the configuration page of the NC-2200w. If it is printed, the USB cable connection between the NC-2200w and the Printer/MFC/DCP is OK.
Check the NC-2200w:
Check the LEDs. When the LEDs are lit as follows, the NC-2200w is working OK.
-
'Link' LED is on (green).
-
'Infra' LED is on when in the NC-2200w is in Infrastructure mode. (Off when in Ad-hoc mode.)
If the LEDs are not lit correctly, remove the AC adopter power cable from the NC-2200w and try again.
-
Check the computer is in Ad-hoc mode.
Make sure your computer has been configured for Ad-hoc mode.
The "Wireless Setup Wizard" can only configure the NC-2200 when in Ad-hoc mode.
To see the quick setup guide, click here (PDF file)
Other Possibilities:
Make sure that you are using the latest firmware version and software for your Brother wireless product, Access Point and wireless LAN card.