MFC-J5845DW(XL)

FAQs & Troubleshooting

FAQs & Troubleshooting

Load Envelopes in Paper Tray #1

  • If the [Check Paper] setting is set to [On] and you pull the paper tray out of the machine, a message appears on the LCD asking if you want to change the paper type and paper size.
  • You can load envelopes in a variety of sizes. See Related Information: Paper Type and Size for Each Operation. 

  • When you load a different paper size in the tray, you must change the Paper Size setting in the machine or the paper size setting on your computer.

    Doing this enables the machine to automatically feed paper from the appropriate tray if Auto Tray Select has been set in the machine or printer driver.

  • Before loading envelopes in the tray, press the corners and sides of the envelopes to make them as flat as possible.
  1. If the paper support flap (1) is open, close it, and then close the paper support (2).
  2. Pull the paper tray completely out of the machine as shown by the arrow.
  3. Remove the tray top cover (1).
  4. Load up to 10 envelopes in the paper tray with the printing surface face down. Loading more than 10 envelopes may cause paper jams.
  5. Gently press and slide the paper width guides (1) and paper length guide (2) to fit the size of the envelopes.

    Make sure the envelopes are flat in the tray.

    IMPORTANT
    If envelopes are "double-feeding," load one envelope in the paper tray at a time.

    If you are using envelopes that are longer than the tray length, such as Com-10 envelopes, extend the tray as follows, and then load the envelopes.

    Rest the tray on a flat surface. Push the green slider to the left and then extend the tray until it locks into place.

  6. Replace the tray top cover.
  7. Slowly push the paper tray completely into the machine.
    IMPORTANT

    DO NOT push the paper tray into the machine forcefully or quickly. Doing this may cause paper jams or paper feed problems.

  8. Pull out the paper support (1) until it locks into place, and then unfold the paper support flap (2).
  9. Change the paper size setting in the machine's menu, if needed.

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

MFC-J5845DW(XL), MFC-J5945DW

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: €Are there any comments you would like to add?

Please note this form is used for feedback only.