TJ-4522TN
 |
FAQs & Troubleshooting |
How to reset the printer settings by directly operating the printer
Printer initialization clears the printer's DRAM and restores its factory settings.
-
Turn off the printer.
-
Press and hold the right Selection button, and then turn on the Power Switch.
-
Release the button when Factory Default appears on the screen.
You can also release the button when the LED is flashing in green (5 times).
The LED color will change in the following order:
Amber > red (5 times) > amber (5 times) > green (5 times) > green/amber (5 times) > red/amber (5 times) > green (lit)
After the initialization, the following factory settings will be restored:
| Parameter |
Default setting |
| Speed |
152.4 mm/sec (6 ips) (203 DPI)
101.4 mm/sec (4 ips) (300 DPI)
76.2 mm/sec (3 ips) (600 DPI) |
| Density |
8 |
| Label Width |
101.5 mm (4") |
| Label Height |
101.5 mm (4") |
| Sensor Type |
Gap sensor |
| Gap Setting |
3 mm (0.12") |
| Print Direction |
0 |
| Reference Point |
0,0 (upper left corner) |
| Offset |
0 |
| Tear Mode |
On |
| Peeler Mode |
Off |
| Cutter Mode |
Off |
| Rewinder Mode |
Off |
| Code Page |
850 |
| Country Code |
001 |
| Clear Flash Memory |
No |
If your question was not answered, have you checked other FAQs?
Have you checked manuals?
If you need further assistance, please contact Brother customer service:
Related Models
TJ-4420TN, TJ-4422TN, TJ-4520TN, TJ-4522TN, TJ-4620TN
Content Feedback
To help us improve our support, please provide your feedback below.
