HL-L8250CDN

FAQs & Troubleshooting

FAQs & Troubleshooting

Replace Drum

The Brother machine has separate consumables the toner cartridge and the drum unit. Verify you replace only the drum unit and not the toner cartridge. If you want to know their difference, refer to "What is the difference between the toner cartridge and the drum unit?"

 

Replace the drum following the steps below:
 

Replacing the drum unit

 

  1. Make sure that the machine is turned on.
  2. Press the front cover release button and then open the front cover.

    Open Front Cover
     
  3. Hold the blue handle of the drum unit. Pull the drum unit out until it stops.

    Pull Drum
     
  4. Turn the blue lock lever (1) at the left of the machine counterclockwise to the release position. Holding the blue handles of the drum unit, lift the front of the drum unit and remove it from the machine.

    Lock Lever Couonterclockwise
     
  5. Hold the handle of the toner cartridge and gently push it forward to unlock it. Then pull it out of the drum unit. Repeat this for all the toner cartridges.

    Pull Toner
     
  6. Unpack the new drum unit and remove the protective cover. 

    Unpack Drum
     
  7. Hold the handle of the toner cartridge and slide it into the appropriate colored section of the drum unit until you hear it click into place.

    Slide Toner

    BK-Black C-Cyan M-Magenta Y-Yellow
     
  8. Make sure the blue lock lever (1) is in the release position as shown in the illustration.

    Lock Lever Release Position
     
  9. Gently slide the drum unit into the machine until it stops at the blue lock lever.

    Slide Drum
     
  10. Turn the blue lock lever (1) clockwise to the lock position. 

    Lock Lever Clockwise
     
  11. Push the drum unit in until it stops.

    Push Drum
     
  12. Close the front cover of the machine.

 

Reset the drum counter

When you replace the drum unit with a new one, you need to reset the drum counter by completing the following steps:

 

  1. Press the Up or Down arrow key (+ or -) to choose Machine Info.. Press OK.
  2. Press the Up or Down arrow key (+ or -) to choose Reset Parts Life. Press OK.
  3. Press the Up or Down arrow key (+ or -) to choose Drum Unit.
  4. Read the message and press the Up arrow key for Reset.

 

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

HL-L8250CDN, HL-L8350CDW, HL-L8350CDWT

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: €Are there any comments you would like to add?

Please note this form is used for feedback only.