HL-5370DW/HL-5370DWT

FAQs & Troubleshooting

FAQs & Troubleshooting

How do I install additional memory?

Follow the procedure below to install additional memory.

 

  1. Turn off the printer power switch, and then unplug the printer. Disconnect the interface cable from the printer.

    Be sure to turn off the printer power switch before you install or remove the DIMM.

     
  2. Remove the DIMM cover.

  3. Unpack the DIMM and hold it by the edges.

    To prevent damage to the printer from static electricity, DO NOT touch the memory chips or the board surface.

     
  4. Hold the DIMM by the edges and align the notches in the DIMM with the protrusions in the slot.
    Insert the DIMM diagonally (1), then tilt it toward the interface board until it click into place (2).

  5. Put the DIMM cover back on.

  6. Reconnect the interface cable to your printer. Plug the printer back in, and then turn on the power switch.

    To make sure that you have installed the DIMM properly, you can print the printer settings page that shows the current memory size.

     
 

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

HL-5240, HL-5250DN, HL-5280DW, HL-5340D, HL-5350DN, HL-5370DW/HL-5370DWT

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.