Can the cutting machine cut all materials automatically with the auto blade?

 

The cutting machine can cut automatically, however the material may not be cut cleanly depending on the material or the pattern. In that case, adjust the Cut Pressure setting. 


 

Before making your project, perform a test/trial cut with the same material and check the cut result.
For details on trial cutting, refer to How do I perform trial cutting? (Test Cut).

Adjust the Cutting pressure according to the test/trial cut results.
If the material could not be cut cleanly, refer to the following table, and adjust the setting for the cutting pressure.

Test/Trial Cut results Tips for adjustment
Part of the pattern is not cut. Pressure too light : Touch image in the settings screen once to increase the pressure.
The entire pattern is not cut. Pressure too light : Touch image in the settings screen once to increase the pressure.
There are deep cuts completely through the mat. Pressure too strong : Touch image in the settings screen once to decrease the pressure.

 

 

 

 

To adjust the Cut Pressure setting, touch image in the home screen, and then adjust the setting for Cut Pressure.
image image image

 

 


Otherwise, touch image in the test screen, and then adjust the setting for Cut Pressure in the settings screen.
image image image

 

 

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

SDX125, SDX125e, SDX125i, SDX125TS, SDX135PRO, SDX225, SDX230D

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: €Are there any comments you would like to add?

Please note this form is used for feedback only.