TJ-4420TN

FAQs & Troubleshooting

FAQs & Troubleshooting

The printed label is wrinkled.

Check the following:
 

Are the ribbon and media loaded correctly?
If not, reload them correctly. For details, see the FAQ: "How to load the Ribbon" or "How to load the Media".

Is the print density correct?
If not, set the suitable density to have good print quality.
Follow the steps below:

  1. Connect your computer and the printer, and then make sure that the printer is turned on.
  2. Start the BPM (Brother Printer Management Tool), and then click the Printer Configuration button.
  3. Check the Density setting in the FBPL tab.

Is the media fed correctly?
Make sure the Media Guide Tips fit the label width.

 

Is the Print Head tension adjusted correctly?
For the best print quality, adjust the Print Head tension using the Print Head Tension Adjustment Knob. Choose one of five levels of tension adjustment depending on the media width you use.
Print Head Tension Adjustment Knob

For a label width less than 50.8 mm (2"), set the Print Head Tension Position Adjustment Slider as close to the label edge as possible to prevent unnecessary friction between the Print Head and the Platen Roller.
Print Head Tension Position Adjustment Slider

1.  Print Head Tension Position Adjustment Slider
2.  Default Setting
3.  Print Head Tension Adjustment Knob

 

Is the ribbon tension adjusted correctly?
To avoid wrinkled labels, adjust the ribbon tension using the Ribbon Tension Adjustment Screw. Choose one of five levels of tension adjustment.

Ribbon Tension Adjustment Screw

1.  Ribbon Tension Adjustment Screw

If your question was not answered, have you checked other FAQs?

Have you checked manuals?

If you need further assistance, please contact Brother customer service:

Related Models

TJ-4420TN, TJ-4422TN, TJ-4520TN, TJ-4522TN, TJ-4620TN

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.