The self-test printout lists the printer's configuration and available memory, and can indicate if there is any dot damage on the heater component.
Self-test printout
1. Model name
2. Firmware version
3. Firmware checksum
4. Printer Serial number
5. Configuration file
6. System date
7. System time
8. Printed mileage (meter)
9. Cutting counter
10. Number of defective dots
1. Print speed (inch/sec)
2. Print density
3. Label size (inch)
4. Gap distance (inch)
5. Gap/Black Mark Sensor sensitivity
6. Code page
7. Country code
8. Quality mode
ZPL setting information
1. Print darkness
2. Print speed (inch/sec)
3. Label size
4. Control prefix
5. Format prefix
6. Delimiter prefix
7. Printer power up motion
8. Printer head close motion
ZPL is emulating for Zebra® language.
RS232 Serial Port configuration
Bluetooth® configuration
1．Printer name
2．Mac Address
3．DHCP
4．IP Address
5．Subnet Mask
6．Gateway
7．RAW Port
Wi-Fi® configuration
1. Numbers of downloaded files
Total and available memory space
2. Print Head check pattern
If your question was not answered, have you checked other FAQs?
