TJ-4010TN

FAQs & Troubleshooting

FAQs & Troubleshooting

Printing the printer configuration (Self-test)

Print the printer configuration after you run Gap/Black Mark Sensor calibration. (To print the Self-test printouts, see the FAQ: "How to execute the printer configuration (Self-test) to debug".)

The self-test printout lists the printer's configuration and available memory, and can indicate if there is any dot damage on the heater component.

 

Self-test printout

SYSTEM INFORMATION

1. Model name
2. Firmware version
3. Firmware checksum
4. Printer serial number
5. Configuration file
6. System date
7. System time
8. Printed mileage (meter)
9. Cutting counter

PRINTING SETTING 1. Print speed (inch/sec)
2. Print density
3. Label size (inch)
4. Gap distance (inch)
5. Gap/Black Mark Sensor sensitivity
6. Code page
7. Country code
Z SETTING 1. Print darkness
2. Print speed (inch/sec)
3. Label size
4. Control prefix
5. Format prefix
6. Delimiter prefix
7. Printer power up motion
8. Print Head close motion
RS232 SETTING RS232 Serial Port configuration
RFID SETTING RFID frequency band region
ETHERNET SETTING 1. Printer name
2. Mac Address
3. DHCP
4. IP Address
5. Subnet Mask
6. Gateway
7. RAW Port
WIFI SETTING Wi-Fi® configuration
DRAM FILE / FLASH FILE

1. Number of downloaded files / Total and available memory space

2. Print Head check pattern

If your question was not answered, have you checked other FAQs?

Have you checked manuals?

If you need further assistance, please contact Brother customer service:

Related Models

TJ-4010TN, TJ-4020TN, TJ-4021TN, TJ-4120TN, TJ-4121TN

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.