How do I make a label with a barcode?

Please follow the steps below:
 

  1. Set bar code parameters
    1. Press the Code key (Code ), then the Bar Code key ( Bar Code ).
    2. Press the left or right arrow key ( Left / Right ) until the parameter that you wish to change is displayed.
    3. Press the up or down arrow key ( Up / Down ) until the desired setting is displayed.
    4. Repeat the step "b" and the step "c" until all parameters are set as you wish.
    5. Press the Return key ( Return ).

  2. Enter the bar code data
    1. Press the Bar Code key ( Bar Code ).
    2. Type in the new bar code data or edit the old data.

  3. Add the bar code to the text
    1. Press the Return key ( Return ) to add the bar code to the text.
       

The following bar code parameters are available:

Parameter Settings
PROTOCOL CODE 39, I-2/5, EAN13, EAN8, UPC-A, UPC-E, CODABAR, EAN128, CODE128
WIDTH< (bar width) SMALL, MEDIUM, LARGE
UNDER# (numbers printed below bar code) ON, OFF
CHECK DIGIT* OFF, ON

 

*The CHECK DIGIT parameter is available only with the CODE 39, I-2/5 and CODABAR protocols.

If your question was not answered, have you checked other FAQs?

Have you checked manuals?

If you need further assistance, please contact Brother customer service:

Related Models

PT-7500, PT-7600

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.