Innov-is NS80e

FAQs & Troubleshooting

FAQs & Troubleshooting

Machine does not start to sew.

 

If the machine does not start when you press the Start/Stop button or press the Foot controller, check the following possible causes and solutions.

 

 

  • The bobbin winder shaft is pushed to the right.

    Slide the bobbin winder shaft to the left until it snaps into place.
    img01
    Refer to "How do I wind the bobbin?".


     
  • Presser foot is not lowered.

    Lower the presser foot.
    img02
    Refer to "Basic procedure to sew stitches".


     
  • Start/Stop button was pressed with the foot controller attached.

    When the foot controller is connected, you cannot use the Start/Stop button.
    Remove the foot controller to use the Start/Stop button, or use the foot controller to operate the machine.


     
  • Start/Stop button was pressed with the buttonhole lever is down while a stitch other than a buttonhole stitch or a bar tack stitch is selected.

    Raise the buttonhole lever before continuing the operation.
    img03 (1) Buttonhole lever

     
  • Start/Stop button was pressed with the buttonhole lever is up while a buttonhole stitch or a bar tack stitch is selected.

    Lower the buttonhole lever before continuing the operation.
    img04 (1) Buttonhole lever

     

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

Innov-is NS80e, Innov-is NS80PRW

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.