PE550D

FAQs & Troubleshooting

How do I remove or attach the Embroidery foot ?

Only use embroidery feet designed specifically for this machine. Use of any other embroidery foot may result in injuries or damage to the machine.

Press (Needle position button) once or twice to raise the needle.
Press .
>>The screen changes, and all keys and operation buttons are locked (except ).
Raise the presser foot lever, use the included screwdriver to loosen the embroidery foot screw, and then remove the embroidery foot.

(1) Screwdriver
(2) Embroidery foot screw
(3) Embroidery foot
Hold the embroidery foot “Q” with your right hand, as shown.
Hold the embroidery foot with your index finger wrapped around the lever at the back of the foot.

(1) Lever
(2) Embroidery foot bar
While pressing in the lever on embroidery foot “Q” with your finger, fit the embroidery foot bar over the needle clamp screw.

(1) Embroidery foot bar
(2) Needle clamp screw
(3) Presser bar
Secure embroidery foot “Q” with the embroidery foot screw, making sure that embroidery foot “Q” is vertical.

(1) Mounting notch
(2) Embroidery foot screw
Hold the embroidery foot in place with your right hand, and then use the included screwdriver to securely tighten the embroidery foot screw.

Use the included screwdriver to firmly tighten the screw of the embroidery foot. If the screw is loose, the needle may strike the presser foot and possibly cause injury.
Slowly lower the presser foot lever.
Raise the presser foot lever to check that the embroidery foot is securely attached.