LS-30

FAQs & Troubleshooting

FAQs & Troubleshooting
  • Date: 02/26/2009
  • ID: faqh00000095_003

How do I clean the bobbin case?

 


  1. Remove the power plug from the outlet.
    Remove the power plug
  2. Raise the needle to its highest position, pull the latch and remove the bobbin case.
    remove the bobbin case
  3. Slide the latch levers out from the retaining ring.
    Slide the latch levers out

  4. Remove the retaining ring.
    Remove the retaining ring.
  5. Remove the hook by grasping the center post and pulling out.
    Remove the hook

    Note it’s position related to the driver.

  6. Remove any accumulated lint and thread with a brush.
    Remove any accumulated lint with a brush

    Clean the lint from the shuttle hook using a cloth dampened with machine oil.

  7. Grasp the center post of the hook, match the hook position opposite the driver and insert.
    Grasp the center post of the hook
  8. Insert the retaining ring with the notch up.
    Insert the retaining ring
  9. Push the latch levers into their locked position.Replace the bobbin cace.
    Push the latch levers

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

LS-1217, LS-1520, LS-1717, LS-2000, LS-2020, LS-2125/2125i/2129, LS2250PRW, LS2300PRW, LS2350, LS2400, LS-30, LX2375, LX3014, LX-3125/3125E, PS-21, VX3240, XL-5130/5232/5340, XL-5500, XL-5600, XL-5700

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.

Submit