TD-4410D

FAQs & Troubleshooting

FAQs & Troubleshooting

Adding a custom media size for continuous roll (Linux®)

To add a custom media size for continuous roll, do the following:

 

  1. Run the command to add a custom media size.
     
    1. Add a new Label Format with the "New Label Format" name and set the 30mm width and length and the 3mm label gap:
      "brpapertoollpr_td4550dnwb -P TD4550DNWB -n Papar_Name -w 30 -h 30 -g 3.0 -b 3 -t 3 -r 1.5 -l 1.5 -e 11 -S [0/1/2] [-m 0.0 -o 0.0]" [Enter]
      (Type the whole command as a single line before you press enter):

       In the case of S=0,1 then program not need (-m 0.0 -o 0.0).
        
      -P Printer Name, e.g. td4550dnwb
      -n New Label Name
      -w label width
      -h label length
      -g label spacing
      -b bottom margin
      -t top margin
      -r right margin
      -l left margin
      -e energyRank[optional]
      -S 0/1/2(0:Continuous Length Roll/1:Die-Cut Label/2:Media With Marks)

      For TD-4420DN(FC)/4550DNWB(FC):

      Set 0 (Continuous Length Roll).

      -m mark
      -o mark offset
       
    2. Remove the Label Format with the "New Label Format" name:
      "brpapertoollpr_td4550dnwb -P TD-4550DNWB -d Paper_Name"  [Enter]

      Enter the Width and Height/Length in mm.

      Superuser authorization is required.

  2. Select the new media size from "Set Printer Options" in "http://localhost:631/printers".
     

  3. Try a test print from "Print Test Page".

If your question was not answered, have you checked other FAQs?

Have you checked manuals?

If you need further assistance, please contact Brother customer service:

Related Models

TD-4410D, TD-4420DN, TD-4520DN, TD-4550DNWB

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.