HL-8050N
FAQs & Troubleshooting |
"JAM E" error appears on the LCD. What should I do?
Follow the procedure below to remove the jammed paper.
-
Open the top cover.
Do not touch any parts inside the printer.
-
Hold the toner cartridge by the grip and pull it out slowly. Then place it on a flat surface.
To prevent the toner from dirtying the surface, lay a piece of paper on the surface before putting the toner cartridge down.
-
Open the offset catch tray cover by pulling the tab at the top left of the cover.
-
Remove any jammed paper.
-
Close the offset catch tray cover.
-
Open the back cover by lifting up the lower gray lever at the top left corner of the back of the printer.
-
Remove any jammed paper. If paper is torn, check for any remaining torn pieces of paper.
- The fuser unit is hot. Be careful not to touch it as you can get burnt.
- Make sure that the levers at both ends of the fuser unit are returned to the positions they were in before clearing the jam.
- If you let go of the cover of the fuser unit, it will return to its original position.
-
Close the back cover.
Make sure that the levers at the back of the printer, as shown in the illustration, are returned to the positions they were in before clearing the jam.
-
Hold the toner cartridge by the grip and insert it into the slot inside the printer.
- Do not touch any parts inside the printer.
- Ensure that the toner cartridge is firmly set.
-
Close the top cover securely.