Innov-is NV180

FAQs & Troubleshooting

FAQs & Troubleshooting

How do I change the needle ?

Before using the needle, place the flat side of the needle on a flat surface and check that the distance between the needle and the flat surface is even.

img01 (1) Flat side
(2) Needle type marking
(3) Flat surface
(4) Even
(5) Not even

Replace the needle in cases such as the four described below:

  1. If an unusual sound is produced when the needle enters the fabric while sewing trial stitches at low speed. (The tip of the needle may be broken or dull.)
  2. If stitches are skipped. (The needle may be bent.)
  3. Generally, after completing one project, such as a piece of clothing.
  4. Generally, after using three full bobbins of thread.

 

 

  1. Press img02 (Needle position button) once or twice to raise the needle.




     
  2. Place fabric or paper under the presser foot to cover the hole in the needle plate to prevent the needle from falling into the machine.



     
  3. Press img03 .
    >> The screen changes, and all keys and operation buttons are locked (except img04 ).
    img05
     

    When replacing the needle, be sure to press img06 on the operation panel to lock all keys and buttons, otherwise injuries may occur if the “Start/Stop” button or any other button is pressed and the machine starts.



     
  4. Hold the needle with your left hand, and then use a screwdriver to turn the needle clamp screw toward you (counterclockwise) to remove the needle.
    img07

    Do not apply a strong force when loosening or tightening the needle clamp screw, otherwise certain parts of the machine may be damaged.
     

    img08

     



     

  5. With the flat side of the needle toward the rear of the machine, insert the new needle until it touches the needle stopper. Using the screwdriver tighten the needle clamp screw by turning it clockwise.
    img09 (1) Needle stopper

    Be sure to insert the needle until it touches the needle stopper and securely tighten the needle clamp screw with the screwdriver, otherwise the needle may break or damage may result.


     

  6. Press img10 to unlock all keys and buttons.
    img11


     

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

Innov-is M380D, Innov-is NV180, Innov-is NV180D, Innov-is NV180K

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.