How do I install/change the RD roll?

Follow the steps below:

 

  1. Press and hold the ON/OFF button Power to turn the printer off.  Pull up the levers on both sides under the RD Roll compartment cover to open it.
    Open cover

  2. Squeeze the green lever and adjust the guide to fit the width of the RD roll. Use the scale molded in the rear compartment to assist positioning this guide.
    Adjust guide

  3. Slide the end of the RD roll under the gap (media) sensor.

    If the end of the RD roll has not been fed under the gap (media) sensor, the printer may not be able to detect the media properly.

    Slide roll

  4. Insert a RD roll into the roll compartment upside down with the labels feeding from the bottom as shown. Check the position of the roll guide and adjust it to prevent the RD roll from moving sideways.

    Incorrect insertion of the RD roll will not print on the correct side of the label.

    Insert roll


  5. Position the end of the RD roll to touch the black plastic cutter guard.
    Adjust position

  6. Close the RD Roll compartment cover.
    Close cover

  7. Press and hold the ON/OFF button Power to turn the printer on.

  8. Die cut label
    Press the Feed button. The printer will position the label to the correct starting position. You are now ready to print.

    Continuous length label
    Press the Feed button twice and the Cut button. The printer will position the label to the correct starting position. You are now ready to print.

If your question was not answered, have you checked other FAQs?

Have you checked manuals?

If you need further assistance, please contact Brother customer service:

Related Models

TD-4000, TD-4100N

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.