4234D

FAQs & Troubleshooting

FAQs & Troubleshooting
  • Date: 08/12/2017
  • ID: faqh00000586_001

How to attach and remove the presser foot

  1. Turn off the main power and light switch or disconnect the electric supply plug.
  2. Raise the presser foot lever. 1
  3. Turn the hand wheel 2 so that the mark on the hand wheel is aligned to the line on the machine.
  4. Push the button on the presser foot holder and the standard presser foot will be released. 3
  5. Raise the presser foot farther by pushing the presser foot lever upward. Then remove the presser foot and store it in a safe location.
  6. Again, raise the presser foot farther by pushing the presser foot lever upward. Then place the presser foot just under the presser foot holder <A> so that the groove in the bottom of the presser foot holder <B> is aligned and catches the bar on the top of the foot <C>. Then lower the presser foot lever to attatch the foot, pushing the button on the presser foot. 4

Attaching/ Removing presser foot

 

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

4234D

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.

Submit