BC-2100/BC-2100PRW

FAQs & Troubleshooting

FAQs & Troubleshooting
  • Date: 08/06/2009
  • ID: faqh00000477_001

How do I draw up the lower thread?

1. Raise the presser foot using the presser foot lever.

Raise the presser foot using the presser foot lever  1 Presser foot lever

 

2. Lightly hold the end of the upper thread.

Lightly hold the end of the upper thread  1 Upper thread

 

3. While holding the end of the upper thread, raise the needle either by turning the handwheel toward you (counterclockwise) so that the mark on the wheel points up or by pressing needle position button (for models equipped with the needle position button) once or twice.
While holding the end of the upper thread, raise the needle either by turning the handwheel or by pressing needle position button

1 Mark on the handwheel     2 Needle position button

 

4. Pull on the upper thread to draw up the lower thread.
Pull on the upper thread to draw up the lower thread

1 Upper thread     2 Lower thread

 

5. Pull out about 10 cm (4 inch) of both threads and pull them toward the back of the machine under the presser foot.
Pull out about 10 cm (4 inch) of both threads and pull them toward the back of the machine under the presser foot

1 Upper thread     2 Lower thread

 

 

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

BC-2100/BC-2100PRW

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: Are there any comments you would like to add?

Please note this form is used for feedback only.

Submit