MFC-L3770CDW

FAQs & Troubleshooting

FAQs & Troubleshooting

Load Paper in the Multi‑purpose Tray (MP Tray)

When you load a different size and type of paper in the tray, you must also change the Paper Size and Paper Type settings in the machine, or on your computer.

  • Plain Paper
  • Thin Paper
  • Thick Paper
  • Recycled Paper
  • Bond Paper
  • Glossy Paper
  1. Lift the support flap to prevent paper from sliding off the face down output tray.
    Lift the support flap to prevent paper from sliding off the face down output tray
  2. Open the MP tray and lower it gently.
    Open the MP tray and lower it gently
  3. Pull out the MP tray support (1) and unfold the flap (2).
    Pull out the MP tray support and unfold the flap
  4. Slide the MP tray paper guides to fit the width of the paper you are using.
    Slide the MP tray paper guides to fit the width of the paper you are using
  5. Load paper with the printing surface face up in the MP tray.
    Load paper with the printing surface face up in the MP tray
    • Make sure the paper is below the maximum paper mark (1).
    • When using glossy paper, load only one sheet at a time in the MP tray to avoid a paper jam.
    • When you use preprinted paper, load the paper in the correct orientation.
    • To remove a small printout from the output tray, use both hands to lift up the scanner cover as shown in the illustration.
      Use both hands to lift up the scanner cover
    • You can still use the machine while the scanner cover is up. To close the scanner cover, gently push it down with both hands.
      To close the scanner cover, gently push it down with both hands

 

If your question was not answered, have you checked other FAQs?

Have you checked the manuals?

If you need further assistance, please contact Brother customer service:

Related Models

MFC-L3770CDW

Content Feedback

To help us improve our support, please provide your feedback below.

Step 1: How does the information on this page help you?

Step 2: €Are there any comments you would like to add?

Please note this form is used for feedback only.